Juego de extractores de rodamientos interiores de 3 mandíbulas

No wrong pull for aram 1500 rear bearing.

For a "blind" bearing that is accessible only from the inside the inner race this worked very well. Used it for rebuilding and replacing a bearing for a boat outboard transmission (Honda 5hp)

I thought it might fit a small bearing, so to the grinder to shrink the arms, it now fits, worked as expected

Worked for removing bearings on Samsung front loading washer. Was fidly and has a tendency to twist off its feet, but it works. There is a technique shown by some on YouTube where you thread a screwdriver horizontally through the feet/legs to apply a counter rotational twist while turning the hex head. This works,. but even better is to use an electric impact wrench with an extra deep socket. This minimizes the twisting of the entire puller.

you do not have to use that T handle it has a socket you can put on the end to tighten the jaws tight as you wish. I was using this to pull out kubota zero turn spindle bearings. Worked perfectly with a impact. You will need a 3/4 socket an/ or wrench. Honestly i went an got a towel to put over the bearing puller as i used the impact that thing go tight tight an started to scare me how much tension it had but it did not care at all over all i am impressed!

Works like a charm, id definitely recommend this puller

It held up to get the job done. I ended up having to file the jaws to keep them from pulling out of the bushing I was using them to pull. Worked much better after that. I would say they are worth the price if only a casual user.

The quality of this Acymner 3 Jaw Inner Bearing Puller Set seems decent, and the tool has a solid weight that makes it feel well built rather than cheap or flimsy. For the price, it seems like it could be a fair value if it works for your specific application.Unfortunately, it did not work for me on a utility cart with a 5/8" bearing I.D. I could barely get the three arms inside the bearing and eventually managed to position them, but the puller would not remove the bearing at all. The bearings I was working with were pressed in very tight.In the end, I had to heat up the wheel, and that allowed me to remove the bearing fairly easy without the tool. This puller was recommended in another review for pulling similar bearings, but it didn’t work in my case. Because of that, I will be …